Should you require any technical or commercial assistance with the selection of your product, please click below to contact us.

Application

There are specific products for either spray or brush applications.
The spray coatings are applied using either airless, air assist or with air atomised equipment. With the air atomised equipment it is necessary to use a spray gun with a fairly large orifice and several sets of atomising orifices for positive
breakup of the heavy coating. A thickness of 500 microns is applied to the mould and checked with a wet film thickness gauge. A coating which is too thin (<300micron) could cause under-cure of the product and too thick a film (>800micron) could crack under flexing.
The brush products are formulated to have the correct drag on the brush, release air and level correctly. As with the spray grades the proper thickness should be applied to achieve the best results.
For colour requirements or specific colour matches speak to your representative.

Storage

Store the products in their original containers with the lids closed and out of direct sunlight. Temperature must be below 25°C for maximum shelf life

Should you require any technical or commercial assistance with the selection of your product, please click below to contact us.

Start typing and press Enter to search